User's Manual

Table Of Contents

2.0 Operation

1. Install a charged Li-Ion battery

2. Set the channel to match that of the MDR2 or other compatible receiving device. Set up

the MDR2 with motors. Apply power.

3. Press the POWER button (5) momentarily. The power LED (4) will light.

4. When the RMF establishes communication with the MDR2, the LINK LED (2) will glow.

The color will indicate the signal strength as described in the previous section.

5. The Micro Force joystick (8) will now control the zoom motor. The Camera Run LED (3)

indicates the camera status.

6. To set Lens Limits:

a. Use the joystick to move the zoom one end of the desired zoom range.

b. While pressing the SET BUTTON, move the zoom to the other end of the range.

c. Release the SET BUTTON.

d. The end limits of lens rotation are indicated by the solid glowing bars (11). The

moving bar shows the current lens position.

e. The limits can be removed by pressing the RESET button momentarily.