Operation Manual

6
USER MANUAL RoadRunner PCDVRR710X
4. Settings
You can set up your DVR before record videos and capture photos in burst. To
finish this operation, you need to connect your DVR to the TV.
Connect to your TV
1. Connect your DVR to the TV by using the supplied HDMI cable.
2. Switch your TV to HDMI mode.
3. Slide the switcher to [ ] to power on your DVR. Your DVR is in preview mode now.
4. While connecting to your TV, use the following buttons to control playback:
- Press [M] to switch among MOVIE, PHOTO, REC and SETUP modes.
- Slide the switcher to [ ] and release it to confirm.
- Press [R] to make a selection.
Set up your DVR
Follow the steps to finish settings:
1. Connect your DVR to the TV by using the supplied HDMI cable.
2. Switch your TV to HDMI mode.
3. Slide the switcher to [ ] to power on your DVR.
4. Press [M] to switch to SETUP mode. The following displays on your TV:
5. Use the following buttons to set up your DVR:
- Slide the switcher to [ ] and release it to confirm and exit.
- Press [R] to make selection.
4