Operation Manual

4
USER MANUAL RoadRunner PCDVRR710X
Be careful not to damage your fingernails when you mounting your DVR.
Insert a memory card
You need to insert a memory card before video recording and taking photos. Depending on the
memory card manufacturer and type, some memory cards may not be compatible with your
device.
1. Unscrew the cover of your DVR.
2. Insert a memory card with the gold-coloured contacts facing downwards.
3. Push the memory card into the slot until it locks in place.
• Some memory cards may not be fully compatible with the device. Using a incompatible
card may damage the device or the memory card, or corrupt the data stored in it.
•Use caution to insert the memory card right-side up.
•If there is no memory card detected when your DVR is powered on, the buzzer will keep
beeping and power off automatically.
• If the memory card is less capacity, the buzzer will keep beeping and power off
automatically.
•Frequent writing and erasing of data shortens the lifespan of memory cards.
Remove the memory card: push the memory card until it disengages from the device, and
then pull it out.
Storage capacity for your reference
Storage card(G) H.264
1080P/30fps
H.264
720P/60fps
H.264
720P/30fps
2592 X 1944
(5M)
8G 90min 150min 200min 10500 photos
4G 45min 70min 100min 5200 photos
2G 22min 35min 50min 2600 photos
1G 10min 17min 25min 1300 photos
Replace the cover
1. Align the cover onto the part of your DVR.
2. Screw to replace the cover.
Power on your DVR
Slide the switcher to [ ] to power on your DVR. You will hear a buzzer beep for 5 times and the
laser indicator light on at the same time. Your DVR goes to standby mode at this time.
To turn off your DVR, slide and hold the switcher to [ ] for a few seconds until you hearing
a long buzzer beep.