User's Manual

54
55
Controls &
Connections
Recording
Tutorials
Technical
Information
Multiple
Mixers
Overview
2 Controls & Connections
2.10 Digital Effects | Master Control
2.10.2 Creating & Recalling a Scene
The StudioLive allows you to create and store a library of scenes. A scene is like a snapshot of
your mix. It stores each Fat Channel parameter for every input and bus, as well as each fader’s
position, the aux and effects mixes, channel mutes and solos, and the input selection (analog input
or FireWire playback stream). Creating a scene requires simply dialing in a mix that you would
like to use at a later date and saving it. This has obvious benets for both studio and live sound
applications. For example, in the studio, saving and recalling a scene allows you to move on to
another song or project and come back to the current mix later. For live shows with multiple bands,
you can set up custom mixes for each band at sound check and recall the mix when that band goes
onstage. You also can save custom mixes for each venue that a band plays repeatedly.
To save a scene, press the Scene button and
Page Down to the second screen. The memory
locations will be selected. Use the Value Encoder
to scroll to a free location in the Scene library.
Now name your scene: Press the Next button to
navigate to the rst letter of the preset name and
turn the Value Encoder clockwise or counter-
clockwise to change the letter. The StudioLive
allows you to customize the name with uppercase and lowercase letters, as well as a selection
of numerals and punctuation marks. Press the Tap button to quickly insert a space. Continue this
process until you are satised with your changes, then press the Store button. It will illuminate while
the Scene is being written to the StudioLive’s internal memory. Once the Scene is saved, the Store
button will return to its unlit status.
Located at position S1 is a scene named Zero Out (Board Reset). This scene cannot be overwritten
and returns your StudioLive to its factory settings. All you have to do it lower the faders and return
all trim knobs and output volume knobs (Solo bus, 2 Track In, Phones, and Monitor) to their lowest
position. Your StudioLive will be zeroed out as follows:
SETTINGS
INPUTS & BUSES ASSIGN PAN SOLO MUTE SELECT LINK SENDS MODE
INPUT CHANNELS MAINS C OFF OFF CH1 OFF NULL
SUBGROUPS NULL C OFF OFF NULL OFF
AUXES 1-6 NULL C OFF NULL OFF PRE
FX A / FX B MAINS C OFF NULL BOTH SET TO F1
AUX IN A & B NULL C OFF NULL
TALKBACK NULL
MAIN BUS C NULL
SOLO BUS AFL
MONITOR BUS MAIN
TAPE IN NULL
METERS NULL
MASTER CONTROL FX