User's Manual

14 15
8. Press the Input button in the Meter
section.
9. While speaking or singing into your microphone, turn the trim knob on Channel 1 until the
signal reaches the desired lev el, but don’t raise it too much or the input will clip. Watch the
level meter.
10. Press the Select button on Channel 1
and bring the fader to unity gain.
11. Press the Main button in the Assign
section of the Fat Channel so that it is
illuminated. This routes the channel to
the main output bus.
12. Bring up the Main fader until you can comfortably listen to your microphone through your
speakers.
13. With Channel 1 selected, you can use the Fat Channel to add dynamics processing and EQ.
For more detailed level-setting procedures and techniques, refer to sections 5.8 and 5.9.3
1 Overview
1.4 Getting Started: Mixing