Operation Manual

14
Using the radio in Scan mode
© To activate Scan mode, press SCAN/DUAL.
© You must have at least two channels in memory to start a scan. However,
you cannot save marine channel 70 or Weather channels.
© You cannot transmit while in Scan mode.
© To save a channel into memory, select the channel, then press MEM/SOS.
The MEM icon displays whenever you tune to that channel.
© To remove a channel from memory, set the radio to that channel, then press
MEM/SOS. The MEM icon no longer displays.
© When the radio stays on a channel, press Channel Up to leave that channel
and resume scanning.
© To end the Scan, press the SCAN/DUAL button again; the radio remains on
the last scanned channel.
Scan mode with Weather Alert Watch
If you activate Weather Alert Watch while in Scan mode, the radio checks the
most recently/used weather channel every seven seconds, then continues
scanning the next channel in memory: