Operation Manual

16
2. Using a 3 mm (or 1/8 inch) drill bit, drill two holes 13 mm (1/2 inch) deep.
3. Use the provided screws to attach the charger to the surface.
Charging the Battery
Your radio includes a charger and a rechargeable bat-
tery pack. Place your radio in the charger with the display
facing forward. Make sure that the CHARGE LED on the
charger turns orange.
Cautions:
• Use only the battery and charger supplied with
this radio. Using a different charger or battery
can damage the radio and create a risk of re or
shock.
• The charger is not waterproof. If the charger falls into the water, unplug
it before attempting to remove it from the water. After you remove the
charger from the water, please contact Customer Service (see the back
cover page for contact information).
• Wipe off dirt or shake water from your radio before placing in the charg-
er if your radio gets dirty or wet.
Important notes on charging the battery
• Charge the battery fully before using the radio. When the battery is com-
pletely charged, the CHARGE LED turns green.
• Don’t use the charger when the ambient temperature is below 5° C (41° F)
or above 40° C (104° F).
• If the radio is powered down, the battery can charge in about seven hours.
(If the radio is powered on, the battery takes longer to charge.)
Installing and Removing the Belt Clip
To install the belt clip:
Slide the belt clip down over the latch until you hear it click.
To remove the belt clip:
1. Lift the at latch.
2. Slide the clip up until it comes free of the latch.