Operation Manual

15
Weather mode with Triple Watch or Dual Watch
If you activate Triple
Watch while operating in
weather mode, the radio
checks channels 9 and
16 every two seconds;
with Dual Watch turned
on, the radio only checks
channel 16.
SETTING UP THE HARDWARE
Install the Battery Pack
Your radio uses the supplied Lithium Ion battery pack. To install the Lithium
Ion battery pack:
1. Remove the belt clip if installed.
2. Use a screwdriver to turn the battery compartment screw counterclockwise
and then lift up and remove the battery cover.
3. Line up the new battery’s connector with the jack inside the battery compart-
ment (the connector only ts one way).
4. Push the connector in rmly. Tug on the battery wires gently to make sure
you have a good connection.
5. Before replacing the battery cover, check the rubber seal located on the
under side of the cover; make sure that the seal is set in the groove and that
there is no foreign matter under the seal.
Note: If the rubber seal appears warn, nicked, or dried out, you
must replace it. New seals are available through the Parts De-
partment (see the cover page for contact information).
6. Replace the battery compartment cover. Tighten the screw securely.
Mounting the Charger
You can mount the charger on any at surface.
1. Use the two holes at the base of the charger as a
template to mark the drill holes.
-