Operation Manual

Scan mode operation

You can save channels into memory and then use scan mode to monitor those

channels from lowest to highest. If the radio detects a signal on a channel, it

stays on that channel as long as the signal is received; when the signal stops,

the radio continues scanning.

Using the radio in scan mode

• To activate scan mode, press SCAN DUAL.

• You must have at least two channels in memory to start a scan.

• You cannot transmit while in scan mode.

• To save a channel into memory, select the channel, then press and hold the

L/M/H MEM key. The “MEM” icon displays whenever you tune to that chan-

nel.

• To remove a channel from memory, set the radio to that channel, then press

and hold the L/M/H MEM key. The “MEM” icon no longer displays.

• When the radio stays on a channel, press Channel Up to leave that channel

and resume scanning.

• To end the scan, press the SCAN DUAL key again; the radio remains on the

last scanned channel.

Scan mode with Weather Alert Watch

If you activate

Weather Alert

Watch while in

scan mode, the

radio checks the

most recently-

used weather

channel every

seven seconds,