Specifications

First, find a location on your dash panel which will give clear viewing and access to the LCD
window. After finding the right location for the indicator unit, mark a 2 in. hole to be cut out. Check
behind the panel for any cables or wiring which could be damaged and then cut out the 2 in. hole.
Test fit the unit in the hole and make any adjustments with our saw or drill. Extending out of the
back of the instrument, you will notice a brass shaft. First attach the U-shaped mounting bracket
over this shaft, place the washer on the shaft and then tighten the nut until the U-shaped bracket
presses tightly to the back of the dash panel.. Look at the front of the instrument to ensure that it
is aligned properly and then tighten securely.
On the rear of the unit, locate the terminal lugs extending out of the rear of the instrument. These
terminal are used to connect the impeller wires.
When shipped from the factory, the transducer is wired with three female lugs attached that need
to be inserted into the male terminal located on the rear of the gauge. Exercise caution when
installing these connectors since improper wiring of the transducer to the wrong terminals can
cause internal damage to the instrument which could cause the unit to fail when power is applied.
BLACK=TRANSDUCER LOW
RED=TRANSDUCER HIGH
BARE SHIELD=BARE
Part Number=703-025
(Terminals)
INSTALLATION: WIRING
INSTALLATION: LTD 260
4
LTD260.qxd 12/15/98 8:24 AM Page 4