Use and Care Manual

- 7 -
Before Using Your Wine Cooler
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
5 Shelves
1 Bottle/Can Basket
1 Instruction Manual
Before connecting the Wine Cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Wine Cooler
This appliance is designed to be free standing only, and should not be
recessed or built-in (fully recessed).
Place your Wine Cooler on a floor that is strong enough to support it when it is
fully loaded. To level your Wine Cooler, adjust the adjustable leg at the bottom
of the unit.
Allow 5 inches of space between the back and sides of the unit, which allows
the proper air circulation to cool the compressor.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized Avanti Products service
center.