Use and Care Manual

- 17 -
Cleaning Wine Cooler
You should do the following operation:
1. Pull out power plug or disconnect the protecting device!
2. Scrub the sealing parts of the door only with clean water and soon wipe the
water off thoroughly.
3. Please clean the wine cooler with slightly warm water and a little detergent
agent. Do not splash water to the operation control element or the lighting
system on the glass door.
4. Reconnect the wine cooler with power source and then connect it with
power source after it has been cleaned.
Hints
Do not use detergent agent or solvent containing sands or acid.
Please regularly clean the scupper, so the dew can be discharged. You can
use small stick or similar objects to clean the scupper.
Energy Saving
Please place the wine cooler in dry and ventilated room! The wine cooler
should not be placed on the location where can be directly irradiated by
sunshine or where is close to heating sources, such as: heating radiator or
cooking stove, etc. If necessary, you can use heating insulation board.
Try to shorten the opening time of door of wine cooler!
First let Wine cool down and then place the Wine into wine cooler!
Try not to open the door too often, especially when the weather is wet or
hot. Once you open the door, mind to close it as soon as possible.
Operation Noise
Normal Noise
Hum the noise is cause by operation of the refrigeration unit.
Coo, rumbling or gurgle the noise is caused by flow of cooling agent in the
pipeline.