Use and Care Manual

- 13 -
Indication of Temperature in Lower Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
Indication of Temperature in Upper Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
: Temperature display.
LIGHT: Lighting button for LED lamp; it controls the on/off of lamp.
POWER: On/off button used to turn on/off all load.
Press LIGHT and POWER together for 2 seconds and you can convert
between fahrenheit temperature and Celsius temperature.
Notice!
 The upper room temperature range is 5~12°C,the down room temperature
range is 12~18°C.the default temperature is 8/15°C, and the temperature
after power failure will be the temperature set before the power failure.
 To elongate the service life of compressor, please wait for at least 5
minutes before the wine cooler is restarted after power failure.
 Failure display
 If there is failure on the sensor, the screen may display failure code, such
as: E and F. When the screen displays the above-mentioned errors, please
do not disassemble it for check by yourself. You should contact local
after-sales service personnel for repair.
 If the temperature in the cooler is too low, it will display “L”.
When the temperature in the cooler is too high, the screen will display “H”
and will flash; under this state, the buzzer will buzz once every one second
until 30 seconds; one minute later, the buzzer will continue to give alarm in the
next 30 seconds; after the alarm is given for three times, it will not give alarm
any more. You can press any key to cancel sound alarm.
 When you put a lot of wines together in the cooler, the temperature in the
cooler may rise temporarily.
Hints for Operation