Use and Care Manual

Installtion Instruction
Before using the wine cooler, remove all packaging materials including bottom
cushions and foam pads and tapes inside the wine cooler, tear off the
protective film on the door and thewine cooler body.
The wine cooler is placed in a well-ventilated indoor place; the ground shall
be flat, and sturdy (rotate left or right to adjust the wheel for leveling if
unstable).
The hot air from side wall of cooler shall be exhausted unrestricted, or compressor's
power will increase and further increase power consumption. Thus the distance between
cooler and walls or neighboring furniture shall not less than 4cm
Wipe the wine cooler inside and outside with warm moist rag (add a small amount of
detergent in the warm water and wipeclean finally with clean water).
The wine cooler shall stay for half an hour before connecting 115V/60Hz
power when it is firstly started.
The wine cooler shall run 2 to 3 hours before loading wine; thewine cooler
shall run for more than 4 hours in summer in advance considering that the
ambient temperature is high.
Please leave enough space to ensure feasible opening .
Dimensions shown are for reference only.
Placement
Start
Keep away from heat and avoid direct sunlight. Do not place the wine cooler
in moist or watery places to prevent rust or reduction of insulating effect.
5
18.9inch
15.4inch
32.9inch
28.7inch