Service Manual Important Safeguards PRF735HW PRF736HS PRF737HB
TABLE OF CONTENTS Specification 3 Safety Precautions 3 The Cooling System 4 Wire Diagram 5 Changing the Reversing Door 5 Changing the Bulb 9 Trouble Shooting 9 2
SPECIFICATION Models PRF735HW/ PRF736HS/ PRF737HB Capacity 7.4 cu.ft. Power Supply 115V/60Hz Rated Input Power 120 W Rated Current 1.5 A Rated Power of Lamp 10 W Refrigerant/Amount R600a / 1.48 oz Net Weight 92 lbs Unit Dimension (HxWxD) 56” x 21 1/2” x 22 3/4” Package Dimension (HxWxD) 58” x 22 5/8” x 23 7/8” Loading QTY(40HQ) 142 pcs SAFETY PRECAUTIONS The installation of this appliance is best carried out by 2 people. Dispose of all packaging carefully and responsibly.
Keep ventilation opening, in the appliance enclosure or in the built-in structure, clear of obstruction This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
WIRE DIAGRAM CHANGING THE REVERSING DOOR Before reversing the door swing, ensure the appliance is unplugged and empty. Provide additional support for the doors while hinges are being removed. Do not depend on the door magnets to hold the door in place. It is recommended that two people perform this task. DO NOT lay the appliance completely flat as this may damage the coolant system. TOOLS REQUIRED Phillips style screwdriver / Flat bladed screwdriver / Hexagonal spanner 1.
2. Remove the 2 screw covers first, then undo the screws underneath. 3. Remove the 2 screws on the back. unscrew 4. Lift the top cover away from the fridge. 5. Remove the three screws, then remove the upper hinge that hold the door in place. Lift the door and place it on a padded surface to prevent it from scratching. unscrew 6. Remove the bolt with a screwdriver and flip the hinge bracket. Then reattach the bolt to the hinge bracket.
. Take off the middle hinge by removing the screws. And then lift the lower door and place it on a padded surface to prevent it from scratching. 8. Move the hinge hole cover of lower door from left side to right side. 9. Remove the screws and bottom hinge. Then remove the adjustable feet from both side. Unscrew 10. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
11. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet. Transfer the lower door to the property position. Screw 12. Make the middle hinge reverse the direction 180°C, then transfer it to the left property position. Make the middle hinge pin in the upper hole of the lower door, then tight the bolts. Ensure the freezer door is aligned horizontally and vertically, so that the seals are closed on all sides before finally tightening the hinge. 13. Place the upper door back on.
REPLACING THE BULB Unplug the AC power cord from the wall. Remove the screw that holds the light bulb cover. Remove the light bulb cover. Unscrew the bulb. Replace with a 10 watt bulb that is the same shape and size. Replace the light bulb cover TROUBLESHOOTING GUIDE PROBLEM Unit does not operate. POSSIBLE CAUSE Not plugged in. The circuit breaker tripped or a blown fuse. The unit temperature control is set at “0” position. The room temperature is hotter than normal.
Manual de mantenimiento Precauciones importantes
