Specifications

Page 16 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
UNI-STA/UNI-EXT
Attaching the Projector
²
Insert the four (4) M6 x 12mm tilt adjustment screws,
two (2) per side.
You can use either the standard hardware or Lock-
It™ security hardware.
³
Tighten all screws.
Do not overtighten the mounting screws.
´
Follow the PDS Installation Instructions to complete
the installation.

Place one (1) nylon washer and one (1) ¼″ at
washer over the hinge pin.
®
Insert and tighten one (1) M6 x 12mm screw.
¯
Repeat  and ® for the opposite hinge pin.
You can use either the standard hardware or Lock-
It™ security hardware. Replace eight (8) M6 x
12mm screws and one (1) M6 x 8mm set screw.
Do not overtighten the M6 x 12mm screws or the
M6 x 8mm set screw.
°
Slide the projector / Projector Plate assembly onto the
PDS Base Box.
±
Hook the Projector Plate over the hinge pins, as
shown.
Base Box Adjustment

You can adjust the roll of the projector by loosening
the three (3) front and rear M6 x 12mm screws.
Do not fully loosen the screws, as the mount may
drop.
®
Set the desired roll and then tighten the screws. First
tighten the center screws and work your way to the
outside screws, making any nal adjustments prior to
tightening the last two screws.
¯
You can adjust the tilt of the projector by loosening
the two (2) M6 x 12mm screws on each side of the
Base Box.
°
Set the desired tilt and then tighten the screws,
making any nal adjustments prior to tightening the
last two screws.
If your projector is not holding the tilt, install the
four (4) external tooth washers on the four (4) M6 x
12mm Phillips head screws w/ Integrated Washers.
±
Once all adjustments have been made, tighten all
hardware.