Specifications

Page 14 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
UNI-STA/UNI-EXT
Attaching the Universal Projector Plate (cont’d)
Step 3
Raise or lower each of the mounting legs, by rotating the
leveling barrels, until all of the mounting legs are at an
equal height.
• Lower the mounting leg by rotating the leveling
barrel counter-clockwise.
• Raise the mounting legs by rotating the leveling
barrel clockwise.

Identify the projector’s approximate front-to-back
center of gravity. Place your hands on each side of
the projector and gently lift it an inch from the surface
on which it is resting. Carefully adjust your grip on the
projector until it seems balanced from front-to-back.
Mentally note the apparent center of gravity.
®
Identify the projector’s approximate side-to-side
center of gravity. Place your hands on the front and
back of the projector and gently lift it an inch from the
surface on which it is resting. Carefully adjust your
grip on the projector until it seems balanced from
side-to-side. Mentally note the apparent center of
gravity.
¯
Place the Universal Projector Plate on top of the
mounting legs with the center hole as close as
possible to the projector’s center of gravity.
Step 4
Step 5

Verify that the mounting legs are at an equal height.
Return to Step 3 if they are not at an equal height or
the Universal Projector Plate is not level.
®
Verify the position of the integrated sliding M6 square
nut in the mounting leg relative to a nearby slot on the
Universal Projector Plate.
If the M6 square nut is not aligned with any slot, you
can use any thin implement, such as a toothpick, to
nudge it into alignment.
Side-to-Side
Center of Gravity
Front-to-Back
Center of Gravity
Sliding M6
Square Nut