Specifications

SPI-PRO
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 15
Attaching the Projector to the Mount (cont’d)
Step 3
M10 x 10mm
Set Screw
Tighten the M4 x 12mm Lock-It™ screw in the
SpiroLock™ collar assembly.
Alignment & Fine-Tuning

Loosen the two (2) M10 x 10mm set screws to ne-tune the projector alignment.
®
Adjust the pitch, roll, and yaw of the projector up to 6° by rmly grasping the projector with both hands and slowly
tilting it forward, backward, and side-to-side.
¯
Make precise adjustments by placing the tip of a at-blade screwdriver between the projector plate and the lip of the
spindle, then using gentle leverage to make any adjustments.
°
Tighten the two set screws in the spindle to lock in your adjustments.
Do not overtighten the set screws.