INSTALLATION INSTRUCTIONS PSD-TL 60” / 72” / 84” Floor Stand NORTH AMERICA 3130 East Miraloma Avenue Anaheim, CA 92806 USA USA and Canada – Phone: 800-368-9700 Fax: 800-832-4888 Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044 ©Premier Mounts 2009 9532-565-001-03 EUROPE Swallow House, Shilton Industrial Estate, Shilton, Coventry, England CV79JY Phone: +44 (0) 2476 614700 Fax: +44 (0) 2476 614710
PSD-TL Table of Contents Warning Statements Parts List Installation Tools Features Support Pole Installation Adapter Installation CTM and PSM Series Installation USA, UFA and RTM-L/S Installation Optional Installations Technical Specifications Warranty 2 3 3 4 5 5 6 7 8 9 10 Warning Statements PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND PROPERTY DAMAGE.
PSD-TL Parts List Congratulations on the purchase of your new Premier Mounts PSD-TL stand. This stand is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Premier Mounts (800) 368-9700. 60” 72” 84” The length will vary depending on the application.
PSD-TL Features Congratulations on the purchase of your new Premier Mounts PSD-TL Floor Stand. When combined with a mount, our floor stand allows you to place a flat-panel in a horizontal or vertical position (with PSM and RTM-L/S mounts only). The flat-panel height is adjustable to any point along the stand’s vertical support poles to achieve the perfect viewing level. The PSD-TL mates directly to our CTM, USA, UFA, RTM-L/S or PSM series of mounts.
PSD-TL Remove the stand out of the box and check for all proper hardware, if missing any hardware please call Premier Mounts. A mount is required to complete the PSD-TL system. Refer to the mount’s installation instructions to install the mounting bracket. Please see Page 8 for optional shelf installation instructions. Support Pole Installation Adapter Installation The PSD-SPA adapter is used with the CTM and PSM Series mounts only. The PSD-SPA is not needed when installing the USA, UFA or RTM-L/S mounts.
PSD-TL CTM and PSM Series Installation This stand is intended for use only with the maximum weights indicated. Use with products heavier than the maximum weights indicated may result in instability causing possible injury. The flat-panel is very heavy; two people are required to lift the flat-panel and secure it to the stand. To install the mounting brackets to the flat-panel, refer to the CTM and PSM installation instructions.
PSD-TL Installing the PSM Support Poles Step 1. For the PSM-Series, secure the back plate to the four (4) threaded mounting points found on the PSD-SPA with the four (4) M10 x 12 bolts and flat washers (supplied). Directional Arrow PSD-SPA Adapter PSM Back Plate M10 Flat Washers M10 x 12mm Bolts PSD-TL Base (facing forward) Step 2.
PSD-TL Optional Installations M8 x 10mm Set Screws Allen Wrench Optional Shelf Suitable Hardware (Commercially Available) PSD-TL Base (not facing forward) Floor Installation Step 1. If securing the base to the floor, use (commercially available) hardware. PSD-TL Base (facing forward) Shelf Installation Do not install the optional shelf higher than 39”. If using a shelf, please install prior to attaching the flat-panel. Step 1.
PSD-TL Technical Specifications All measurements are in inches(mm).
PSD-TL Warranty PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Warranty and for How Long Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of the original owner of this product. The limited warranty is valid only for the original purchaser of the product. What Premier Mounts Will Do At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is defective.
