Specifications

PDS-PLUS/PDS-PLUS-W
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 13
Attaching the PDS-PLUS/PDS-PLUS-W Base
Step 2

Raise the projector (with the mounting bracket
attached) and hook the projector bracket over the
hinge pins.
®
Make sure the bracket is resting on the Base Box
before letting go of the projector.
Step 1

Insert the four (4) M6 x 12mm tilt adjustment screws,
two (2) per side.
You can use either the standard hardware or Lock-
It™ security hardware.
®
Tighten all screws.
Do not overtighten the mounting screws.

Place one (1) nylon washer and one (1) ¼″ at
washer over the hinge pin.
®
Insert and tighten one (1) M6 x 12mm screw.
¯
Repeat  and ® for the opposite hinge pin.
You can use either the standard hardware or Lock-
It™ security hardware. Replace eight (8)
M6 x 12mm screws and one (1) M6 x 8mm set
screw.
Step 3
Proceed to the “Base Box Adjustment” section.