Specifications

PDS-PLUS/PDS-PLUS-W
Page 12 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
Single Mounting Point Installation
If your projector has only one mounting point, a
¼-20 x 5/16” screw must be used to attach the mount to
the projector. Please refer to the following three steps:

Determine where the mounting point is located.
®
Place the projector plate over the mounting point.
¯
Insert the ¼-20 x
5
/16” security screw.
Do not overtighten the ¼-20 x
5
/16″ screw.
Proceed to the “Attaching the
PDS-PLUS/PDS-PLUS-W Base” section.
Step 7

Attach the Projector Plate (if not already attached) to
each of the mounting legs by inserting and tightening
one (1) M6 x 12mm screw through the Projector Plate
into the M6 square nut on each of the mounting legs.
Do not overtighten the M6 x 12mm screws.
®
Insert one (1) Barrel Cap into the end of each leveling
barrel (except the security leveling barrel).
Proceed to the “Attaching the
PDS-PLUS/PDS-PLUS-W Base” section.