Specifications

P4263FP
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 9
➊
Insert a concrete wedge anchor into each hole.
If necessary, lightly tap each concrete wedge anchor
into place with a hammer.
➋
Remove the nuts and washers from all four (4)
concrete wedge anchors.
➌
Replace the washers which you removed from
the concrete wedge anchors with the
5
/16″ washers
shown in the parts list on Page 3.
Step 3
➊
Place the wall plate against the wall over the
threaded shafts of the concrete wedge anchors.
➋
Attach the nuts and
5
/16″ washers to each of the
concrete wedge anchors and tighten using a socket
wrench and an M10 socket.
Do not overtighten the wedge anchor nuts.
Proceed to the “Installing the Mounting Bracket”
section.
Step 4
Installing the Wall Plate (cont’d)
Step 1
Steel Stud Installation
➊
Identify the general location on the wall where you
will be mounting your at panel.
➋
Use a stud nder to determine the exact center
of each steel stud in the vicinity of the mounting
location.
➌
Use a pencil and mark the exact center of each
steel stud.
The supplied M6 steel stud anchors must be used
to install your Premier Mounts’ mount to steel
studs. Do not use lag bolts or wood screws.
Steel Stud Anchor Screw Steel Stud Anchor Sleeve
X