Specifications

P4263FP
Page 8 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
The supplied
5
/16″ concrete wedge anchors must be
used for concrete installation.
You will need a
5
/16″ concrete drill bit, which is
available at your closest hardware store.
Concrete Installation
Installing the Wall Plate (cont’d)
Two people are recommended for this step; one
person to level the wall plate and another person
to mark the mounting locations.
➊
Place the wall plate against the wall in the desired
viewing location.
➋
Level the wall plate.
➌
Use a pencil and mark 2 upper and 2 lower
mounting locations where you will be drilling holes
for the concrete wedge anchors. Each horizontal
location cannot be closer than 12″ apart.
➍
Set the wall plate to one side in a safe location.
Step 1
Use a power drill and
5
/16″ masonry drill bit to drill a hole
at each of the marks.
Step 2
Concrete Wedge Anchors
Example of
5
/16″ Concrete Drill Bit (Not Included)
Step 7
➊
Insert one (1)
5
/16″ x 3″ lag bolt and one (1)
5
/16″ washer
into each pilot hole
➋
Tighten all lag bolts using a socket wrench and ½″
socket.
Do not overtighten the lag bolts when attaching the
mount to the wall. Improper installation may result in
personal injury or property damage.
Proceed to the “Installing the Mounting Bracket”
section.
>12”