Specifications

P4263FP
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 15
Leveling Screw Adjustment
If your at panel is tilted too far to one side, the leveling
screws will allow you compensate for this tilt by simply
adjusting the screws with a screwdriver.
➊
Loosen both locking screws.
➋
Adjust the tilt of your at panel.
➌
Tighten both locking screws.
Mounting Bracket Adjustments
Locking Screw Adjustment
After you have nished leveling your at panel, be sure
to tighten the two (2) M6 x 250mm locking screws.
M6 x 250mm
Locking Screw
(1 per Bracket)
M6 x 250mm
Leveling Screw
(1 per Bracket)
This section requires two people.
Do not release your at panel until you are certain that top and bottom hooks of both mounting brackets are
securely seated on the upper and lower mounting rails of the wall panel.
➊
Raise the at panel past the top and bottom mounting rails on the wall panel.
➋
Slide the at panel down slowly, keeping it close to the wall.
➌
Engage the top and bottom mounting brackets to the rails of the wall plate.
Proceed to the “Mounting Bracket Adjustments” section.
Attaching the Flat Panel to the Wall Plate
Installing the Mounting Bracket (cont’d)
Caution!
It is possible to dislodge your at panel while you
level your at panel. Use extreme caution until
you tighten the locking screws.
Do not overtighten the locking screws.