Specifications

P4263FP
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 11
Selecting the Mounting Hardware
➊
Insert a small straw or toothpick into the threaded
inserts found on the back of the at panel.
➋
Use a pencil to mark the depth of the threaded
insert on the small straw or toothpick.
➌
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
➍
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
➎
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the
mark.
➏
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Proceed to the “Universal Washer Installation”
section.
Installing the Mounting Bracket
➊
Align the wall plate over the steel stud anchor sleeves.
➋
Insert a steel stud anchor screw and a
5
/16″ washer into
each steel stud anchor sleeve.
➌
Use a Phillips screwdriver and tighten each steel stud
anchor screw until it is just snug.
Do not overtighten the steel stud anchor screws.
Do not use a power drill to tighten the steel stud anchor
screws.
Proceed to the “Installing the Mounting Bracket”
section.
Step 5
Installing the Wall Plate (cont’d)
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark