Specifications

P4263FP
Page 10 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Step 4
Use a Phillips screwdriver to tighten each steel
stud anchor screw until the legs have completely
compressed against the back of the steel stud.
The steel stud anchor screw will feel tight when
you rst begin to turn it until the legs begin to
compress. The steel stud anchor screw will then
turn easier for several turns. The steel stud anchor
screw will again feel tight when the legs have
completely compressed against the back of the
drywall. Stop turning the steel stud anchor screw
at that point.
Do not overtighten the steel stud anchor screw.
Remove the steel stud anchor screws and set them
aside.
Steel stud anchors may come with small paper
washers. You may leave them on the screw or
discard them. These small paper washers do not
replace standard
5
/16″ washers.
➊
Use a power drill and
7
/16″ drill bit to drill a hole at
each of the marks.
➋
Insert a steel stud anchor into each hole.
If necessary, lightly tap each steel stud anchor into
place with a hammer.
Step 3
Installing the Wall Plate (cont’d)
Step 2
➊
Place the wall plate against the wall in the desired
viewing location.
➋
Adjust the wall plate to match the locations of the
steel studs.
➍
Level the wall plate.
➎
Use a pencil and mark 2 upper and 2 lower
locations where you will be drilling holes for the steel
stud anchors.
➏
Set the wall plate to one side in a safe location.