Specifications

MVW46
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 7
Step 3

Slide the MVW46 to the desired height on the dual-
pole cart or stand.
®
Insert four (4) M8 x 10mm set screws into the
MVW46 screw holes near the tubing (see drawing).
¯
Tighten the screws against the MVW46 and tubing.
Front-View Closeup of MVW46
Tubing of Cart or Stand
M8 x 10mm Set Screw
Step 4
All at-panel display
illustrations are shown for
example purposes only.
Universal spacers are needed
only for the NEC X461UN or
NEC X461UN2 to prevent their
display handle from hitting the
MVW46.
• If you are installing a Samsung 460UT or
Samsung 460UT-2, attach four (4) 8mm quick-
release buttons and four (4) M8 x 20mm pan
Phillips screws to the display’s back mounting
holes.
• If you are installing an NEC X461UN or NEC
X461UN2, attach four (4) universal spacers, four
(4) 6mm quick-release buttons and four (4) M6 x
30mm pan Phillips screws to the display’s back
mounting holes.
Do not overtighten the screws.
Step 5
Attach the at-panel display to either side of the MVW46
by inserting the display’s quick-release buttons into the
keyhole mounting slots on the MVW46, locking them into
place.
To align a videowall better, attach the rst at-
panel display in the lower-left corner if the keyhole
mounting slots point down-left , or attach it to the
lower-right corner if the keyhole mounting slots point
down-right . Then install the rest of the displays
working clockwise.
The Samsung 460UT or Samsung 460UT-2 should
t into the MVW46’s outer keyhole mounting slots.
The NEC X461UN or NEC X461UN2 should t into
the MVW46’s inner keyhole mounting slots.
Keyhole Mounting
Slot