Specifications

IPM-700 Series
Page 6 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing to a Wall (cont’d)
Drywall or Concrete Installation
#10 Screw Anchor
#10 x 1¼"
Wood Screw
Figure 2
Figure 3
Figure 4
➊
Cut or punch out the corner screw holes on the paper
template (marked “X”) (Figure 1).
➋
Place the paper template at the desired location on
the drywall or concrete surface.
You may install the back plate in portrait or landscape
orientation. If portrait orientation, make sure the
directional arrows on the paper template and back
plate are facing up .
➌
Mark where the corner screw holes will be on the wall
according to the paper template (Figure 2).
➍
Remove the paper template.
➎
Drill pilot holes at the marked locations using a 3/16"
drill bit.
For concrete installation, use a 3/16" concrete drill
bit.
➏
Insert four (4) #10 screw anchors into the four holes
in the wall (Figure 3).
If necessary, use a hammer to lightly tap each screw
anchor into the wall.
➐
Place the back plate against the wall, making sure the
corner screw holes align with the screw anchors.
➑
Insert four (4) #10 x 1¼” wood screws into the corner
screw holes to fasten the back plate to the wall
(Figure 4).
Continue to the “Installing the iPad™” section on
page 13.
Are you installing the IPM-700 with a GB-INWAVP
GearBox™ on a drywall surface?
If Yes, go to the “With GB-INWAVP” section on
page 7.
If No, continue to the “Without GB-INWAVP”
section below.
Do not use the IPM-700 Series with GB-INWAVP on
concrete.
Without GB-INWAVP
C
L
L
C
CUT THIS LINE IF USING GB-INWAVP
THIS SIDE UP
CUT THIS LINE IF USING GB-INWAVP
CUT THIS LINE IF USING GB-INWAVP
CUT THIS LINE IF USING GB-INWAVP
X
Figure 1
X
X X