Specifications

IPM-700 Series

Page 5 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions

Installing to a Wall

Are you installing the IPM-700 to a wood stud, or

drywall or concrete?

If Wood Stud, continue to the “Wood Stud

Installation” section below.

If Drywall or Concrete, go to the “Drywall or

Concrete Installation” section on page 6.

Wood Stud Installation

#10 x 2"

Wood Screw

➊

Cut or punch out the top and bottom middle screw

holes on the paper template (marked “X”) (Figure 1).

➋

Place the paper template at the desired location on

the wood stud.

You may install the back plate in portrait or landscape

orientation. If portrait orientation, make sure the

directional arrows on the paper template and back

plate are facing up .

➌

Mark where the top and bottom middle screw holes

will be on the wall according to the paper template

(Figure 2).

➎

Remove the paper template.

➏

Drill pilot holes at the marked locations using a 3/16"

drill bit.

➐

Place the back plate against the wall, making sure the

screw holes align with the pilot holes.

➑

Insert two (2) #10 x 2” wood screws into the middle

screw holes to fasten the back plate to the wall

(Figure 2).

Continue to the “Installing the iPad™” section on

page 13.

Figure 2

Figure 3

Figure 1

CUT THIS LINE IF USING GB-INWAVP

THIS SIDE UP

CUT THIS LINE IF USING GB-INWAVP