Specifications

IPM-700 Series
Page 13 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing the iPad™
If you are using an iPad2™, attach two (2) rubber
edge trims to the long tabs of the back plate as
shown (Figure 1).
Then attach four (4) adhesive-backed bumpers to
the notches on the back plate (Figure 2).
➊
Place the iPad™ on the back plate by easing it
against the top brackets, then the bottom brackets
(Figure 3).
➋
Center the iPad™ on the back plate.
➌
Insert two (2) M3 x 12mm nylon pan head screws
into the top brackets, then tighten them against the
iPad™ to secure it inside the back plate (Figure 4).
Continue to the “Attaching the Cover” section on
page 14.
Rubber Edge Trim
M3 x 12mm
Nylon Pan Head Screw
Figure 1
Figure 2
Figure 3 Figure 4
➋
Adhesive-Backed
Bumper
➊