Specifications

IPM-700 Series
Page 12 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing to a Wall (cont’d)
Installing the IPM-700 Series Over the GB-INWAVP
➊
Drill pilot holes at the marked locations using a 3/16"
drill bit.
➋
Insert four (4) #10 screw anchors into the four holes
in the wall (Figure 1).
If necessary, use a hammer to lightly tap each screw
anchor into the wall.
➌
Place the back plate against the wall, making sure the
corner screw holes align with the screw anchors.
If you are using portrait orientation, make sure the
directional arrow on the back plate is facing up .
➍
Insert four (4) #10 x 1¼” wood screws into the corner
screw holes to fasten the back plate to the wall
(Figure 2).
Continue to the “Installing the iPad™” section on
page 13.
#10 Screw Anchor
Figure 1
Figure 2
#10 x 1¼"
Wood Screw