Specifications

IPM-700 Series
Page 11 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing to a Wall (cont’d)
Outlet Box Installation
Installation of electrical power to your GB-INWAVP
should be performed by a qualied professional
electrician. Improper installation and handling of
live electrical wires can result in property damage
and severe personal injury.
The 110 volt duplex receptacle, exible aluminum
conduit, and electrical wiring are not included with
your GB-INWAVP. You or your electrician can
purchase these at your local hardware store or
electrical supply shop.
The following steps presume that you have already
run exible aluminum conduit and electrical wiring
up to your GB-INWAVP.
Not Included
Step 1
➊
Remove one of the ½˝ knockouts from the back of the
Outlet Box.
➋
Connect the exible aluminum conduit using
commercially available conduit connectors most
appropriate for your specic installation.
➌
Install a 110 volt duplex receptacle into the Outlet
Box.
➍
Place the Outlet Box into your GB-INWAVP.
Step 2
Secure the Outlet Box to your GB-INWAVP using four
(4) 6-32 x ½" screws.
Do not overtighten the 6-32 x ½” screws.
Proceed to the “Installing the Cable Bushings”
section below.
Installing the Cable Bushings
The knockouts for your audio / video / data cables should
already be removed. If you have not removed them
yet, press hard with your ngertips on either side of the
knockouts, then twist the knockout until they come free.
Watch for sharp edges!
➊
Install the cable bushings gently pressing them into
the knockout holes.
➋
Run your audio, video, and data cables through the
cable bushings.
Continue to the “Installing the IPM-700 Series Over the
GB-INWAVP” section on page 12.