Specifications

GB-MS1
Page 8 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
• If you are using the Premier Mounts PSD-PVW1 (single-display) adapter or PSD-PVW2 (back-to-back display)
adapter to mount the GB-MS1 to a single-pole stand or 2” schedule 40 ceiling pipe, continue to the PSD-PVW1 or
PSD-PVW2 Installation section below.
• If you are using the Premier Mounts PSD-S ceiling adapter to mount the GB-MS1 to a standard 1-1/2" NPT
extension ceiling pipe, go to the PSD-S Adapter Installation section on page 9.
Adapters are sold separately. You may also use other Premier Mounts adapters with 4½" bolt patterns. Please
see www.mounts.com for more information. Refer to the installation instructions that are included with these
respective mounting congurations.
Before starting the following steps, the appropriate suspension device must be installed. Premier Mounts
offers several suspension devices. Please see www.mounts.com for more information. Refer to the installation
instructions that are included with these respective mounting congurations.
Single-Pole Stand or Ceiling Adapter Installation
PSD-PVW2 adapter
(not included)
Figure 2
Figure 1
PSD-PVW1 or PSD-PVW2 Installation

Insert the PSD-PVW1 or PSD-PVW2 adapter into
the stand or ceiling pipe.
®
Select the desired height and secure the adapter
with the two (2) M8 socket head screws (supplied
with the adapter) (Figure 1).
¯
Secure the GB-MS1 back plate to the adapter
using four (4) M10 x 12mm bolts and at washers
(supplied with the adapter) (Figure 2).
Proceed to “Installing the Media Box Bracket” on
page 11.
Hex Key
PSD-PVW1
Sockethead
Screws (2)
Sockethead
Screws (2)
Hex Key
PSD-PVW2
M10 Bolts
2” Pipe
GB-MS1 Wall Plate
Flatwashers
Flatwashers
GB-MS1 Wall Plate
GB-MS1 Wall Plate
M10 Bolts
PSD-PVW1 adapter
(not included)