Specifications

GB-MS1
Page 6 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing the Back Plate
Introduction
The Directional Mounting Arrow stamped into the GB-MS1 back plate indicates which
edge is the top. Two people are recommended to install the back plate.
The GB-MS1 can be mounted to a cart, stand or ceiling using the appropriate Premier
Mounts adapter (sold separately).
• If you are mounting to a wall, continue to the Wall Installation section below.
• If you are mounting to a single-pole cart/stand or the ceiling, go to the Single-Pole Cart/
Stand or Ceiling Adapter Installation section on page 8.
• If you are mounting to a dual-pole cart or stand, go to the Dual-Pole Cart/Stand Adapter
Installation section on page 10.
You must secure the back plate to two (2) wooden
wall studs with four (4) lag bolts (2 lag bolts for
each stud found).

Use a stud nder to determine the exact center of
wall studs in the vicinity of the back plate.
®
Use a pencil to mark the exact center of each of the
wall studs.
Step 1
Step 2
Step 3
Two people are recommended for this step; one
person to level the back plate and another person
to mark the wall stud location.

Place the back plate against the wall in the desired
viewing location.
®
Adjust the back plate to align the mount slots in the
back plate with the center of the wall studs.
¯
Level the back plate.
°
Use a pencil to mark the upper right mounting
location along the center of the wall stud.
Drill a “pilot hole” in the center of the upper right mark
using a ¼″ drill bit and power drill.
Only use a ¼˝ drill bit when drilling pilot holes.
X
X
X
X
X
X
Wall Installation