Specifications

GB-MS1
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 17
Locking Safety Screw Installation
The locking safety screws keep the at panel from
being accidently dislodged from the GB-MS1.

Thread an M6 x 30mm locking safety screw at the
bottom of one of the mounting brackets.
®
Use a Phillips head screwdriver to tighten the
locking safety screw.
¯
Repeat

and
®
for the other locking safety screw.
Do not overtighten the locking safety screws.
Tilt Adjustment
Adjusting the Flat Panel Friction Tilt Angle

Place one hand at the center top edge of the at
panel.
®
Place the other hand on the center bottom edge of
the at panel.
¯
Using the upper hand, gently pull the top of the
at panel towards you while the lower hand gently
pushes the bottom of the at panel away from you.
Adjusting the Flat Panel to the Original Position

Place one hand at the center top edge of the at
panel.
®
Place the other hand on the center bottom edge of
the at panel.
¯
Using the upper hand, gently push the top of the at
panel towards the wall while the lower hand gently
pulls the bottom of the at panel away from the wall.
M6 x 30mm
Locking Safety Screw
(1 per Bracket)