Specifications

GB-MS1
Page 14 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing the Mounting Brackets (cont’d)
Flat Panel
Griplate™ Washer
Nylon Spacer
Mounting Bracket
Mounting Point
Mounting Screw
Griplate™ Washer Installation
Premier Mounts’ Griplate™ washers are designed to
accommodate M4, M5, M6 and M8 hole sizes required by
at panels.
Do not place excessive pressure on the back of the
at panel, as this may damage the at panel.
The Griplate™ washers must be installed between
the head of the mounting screw and the mounting
bracket as shown.
The dimples on the Griplate™ washers must be
oriented as follows:
● The Griplate™ washers installed at the top
of the at panel must have the points of the
dimples facing away from the at panel.
● The Griplate™ washers installed at the bottom
of the at panel must have the points of the
dimples facing towards the at panel.
Does the at panel have:
● Recessed mounting points?
● Uneven mounting points?
● A curved back?
● Any obstruction near the mounting point?
If Yes, you must install nylon spacers. Proceed to the
“Nylon Spacer Installation” section below.
If No, you do not need nylon spacers. Proceed to the
“Attaching the Flat Panel” section on page 15.
Nylon Spacer Installation
Premier Mounts’ nylon spacers allow you to attach the
mounting bracket to at panels which have recessed
or uneven mounting points. Each nylon spacer will add
distance between the mounting bracket and the at
panel.
The nylon spacers must only be installed between
the mounting bracket and the at panel.
The nylon spacers will t M4, M5, M6 and M8 screw
sizes.
Proceed to “Attaching the Flat Panel” on page 15.
M8
M6
M5
M4
Griplate™
Washer
Flat Panel
Mounting Point
Bracket
Top
Griplate™ Washer
Dimple Orientation
Bottom
Griplate™ Washer
Dimple Orientation