Specifications

Fine Tune Projector Mount
Page 10 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
Selecting the Mounting Hardware

Insert a small straw or toothpick into the thread
inserts found on the bottom or top of the projector.

Use a pencil to mark the depth of the thread insert on
the small straw or toothpick , as shown in Figure 1.

Insert the small straw or toothpick into the remaining
thread inserts to compare and verify their depth.

Locate the correct diameter screw for the thread
insert.
If the screw you selected is longer than the mark
on the small straw or toothpick, as shown in Figure
2 and Figure 3, do not use this screw. The screw
length must not bypass the mark.

Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Does your projector have multiple mount points or a
single mount point?
If your projector has multiple mount points, proceed
to the “Multiple Mount Point Installation” section.
If your projector has a single mount point, skip to
the “Single Mount Point Installation” section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Attaching the Universal Projector Plate