Specifications

CTM-MS4
Page - 12 - Installation Manual
4. Use a screwdriver to remove the lower mounting rod
screw.
5. Once the mounting rod screw is removed, insert one
(1) 1 ¼˝ set screw.
6. Once the mounting rod set screw has been inserted
into the first wall plate, place the second wall plate
next to the first wall plate.
7. Line up the mounting hole with the mounting rod set
screw and then slide the two wall plates together.
8. Slide the mounting rod onto the wall plate set
screw and slowly thread the rod onto the set screw
until tight.
9. Insert two (2) M8 x 16mm hex head bolts through the
two holes and secure with two (2) M8 hex nuts.
10. Once the bolt and nut have been attached and finger
tightened, use a wrench (not supplied) to tighten
them.