Specifications

AM225
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 11
Attach a P-Series Mount and/or Accessories
AM225 with P4263T tilt
mount
Use four (4) M8 x 16mm pan Phillips screws to attach
the P-Series P4263F or P4263T at-panel mount to the
AM225.
Follow the installation instructions included with the
P-Series mount.
Make sure the P-Series mount is aligned to the
center of the pullout portion of the AM225.
Proceed to the “Post-Installation Adjustments”
section.
Post-Installation Adjustments
➊
Remove the M5 top-side screws on location “A” to
swivel.
You cannot re-insert the top-side screws unless the
mounting plate is centered.
Do not remove the M8 middle screw.
➋
Use an M2.5 Allen wrench to loosen the screws on
locations “B” to adjust the pullout tension.
Stop loosening when the desired tension is
achieved.
Proceed to the “Cable Routing” section.
Back view of the AM225
pullout mount
A
B
AM225 with P4263F at
mount