Specifications

AM225
Page 10 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing the Pullout Mount
M8 x 12mm combo Phillips
screw
M5 x 8mm combo Phillips
screw
Fig. 1
Fig. 3
M8 x 12mm combo Phillips
screw
Pullout Mount
Wall Frame
➊
Pre-install two (2) M8 x 12mm combo Phillips
screws in the top screw holes of the wall frame
(Fig.1) using at least 5 full turns.
Leave a gap between the heads of the screws and
the wall frame for hanging the pullout mount.
➋
Hang the pullout mount on the M8 x 12mm combo
screws that were pre-installed in the wall frame
(Fig. 2).
The keyhole design of the pullout mount’s
screw holes makes hanging easier.
➌
Use (2) M8 x 12mm combo Phillips screws to attach
the bottom of the pullout mount to the wall frame
(Fig. 3).
➍
Use two (2) M5 x 8mm combo Phillips screws to
attach the middle of the pullout mount to the wall
frame (Fig. 3).
➎
Tighten the top M8 x 12mm combo Phillips screws.
Proceed to the “Attach a P-Series Mount and/or
Accessories” section.
Fig. 2