Installation Guide

1. Remove old pop-up drain
assembly.
4. Thread lock nut from underside of
sink until rubber washer sits securely
inside opening of sink. Tighten lock nut.
7. Insert bottom of lift rod into hole at top
of lift rod strap. Tighten with thumb
screw.
1.Position faucet. Apply clear silicone latex
caulk to base plate.
2. Secure with mounting nuts. Clean up excess
silicone(follow clean-up instructions on label).
3. Apply pipe joint tape to inlet port threads in a
counter-clockwise direction.
4. Slip coupling nut onto supply line.
5. Hand-tighten supply line onto inlet port.
Do not overtighten.
7. Apply joint tape to shank threads in a
clockwise direction.
8. Tighten nut. Do not overtighten.
6. Slip compression nut and compression ring
onto supply line. Insert tube into shank.
9. Aftet installing faucet, remove aerator and
turn on water to remove any left over debris.
Replace aerator and firmly Tighten by hand.
Lift Rod
Strap
Ball Rod
Retaining Nut
Straddle Clip
Stopper
Flange
Rubber Washer
Lock Nut
Rod Port
Drain Assembly
2. Place a ring of putty around
drain opening of sink.
5. Insert main plunger into drain. Insert
ball rod into rod port and into hole at
bottom of main plunger.
6. Place one end of spring clip on end
of ball rod. Pass the tip of the rod
through the hole in the lift rod strap
and then through the hole on the
other end of the spring clip .
3. Insert threaded end of drain body up
through drain hole and attach flange
to body.
Two Handle Lavatory Faucet
Pop-up Drain Installation
1-a Index Button-Cold A66D719C
1-b Index Button-Hot A66D719H
2 Metal Handle Assembly A66E330
3 Handle Trim Ring A667054
4 Retainer Nut A016026
5-a Ceramic Disc Cartridge-Cold A507072W
5-b Ceramic Disc Cartridge-Hot A507071W
6 Aerator A500872N
7 Putty Plate A011084NF
8 Lock Nut Set A504023
9 Lift Rod A025341
10 Pop-up Assembly A556200
Customer Service
For additional assistance,
service or parts for your
Premier Faucet,
Call 1-866-745-4010. or visit
Website: www. premierfaucet. com
TOOLS:
CLEANING:
Philips screwdriver Pliers
Pipe tape
Adjustable wrench Hex wrench
E SSEN
120576/120577/120578
120576LF/120577LF/120578LF
Model number:
Warning and Notes:
Check with local plumbing code requirements before installation; This product should be installed by a local licensed plumber; To meet EPA requirements,
replace original aerator after flushing lines.
INSTALLATION STEPS:
Exploded Drawing:
1-b.
3.
4.
5-a.
5-b.
2.
1-a.
6.
7.
8.
9.
10.