Owner's Manual
Table Of Contents
- Installation Instructions for Backwashing Systems with Fleck 5600 and 5600SXT
- Thank You
- Before You Begin
- Basic plumbing skills are required for installation. If you are unsure of your abilities to install the system using these instructions please hire a qualified plumber.
- Read through your parts list and verify all components are accounted for and in good condition BEFORE scheduling a plumber.
- Please read through the entire instruction manual carefully. If hiring a plumber ensure they have a copy before they start.
- Most common questions are answered in the instructions or FAQ section. If you have read both of those and still have questions you may contact us for further help.
- Plumbing related questions need to be directed to a locally qualified plumber. We are not plumbers and any plumbing questions we receive will not be answered.
- System Requirements
- Before you start plumbing
- Plumbing the system in
- Frequently Asked Questions
For initial programming enter master programming by setting the clock to 12:01 pm. To set
the time of day press and hold the up OR down arrow until the service icon is replaced with
the programming icon. Use the up and down arrows to set the time of day (PM is indicated in
the upper right corner of the screen). Hold the arrow button to advance quickly through the
time. Once the time is set, press the extra cycle button to save the setting. Once the
parameter display is gone, press and hold the up AND down arrow buttons together for 5-10
seconds until the programming icon appears and [DF] is shown in the parameter code. Once
each setting has been entered, use the extra cycle button to advance to the next setting.
Please Note: Most of these settings will be left alone.
Depending on your system some settings may not be shown, and some settings may be
different than shown here. Do not change any settings unless specifically instructed to do so
by these instructions or one of our techs.