Owner's Manual
Table Of Contents
- Installation Instructions for Backwashing Systems with Fleck 5600 and 5600SXT
- Thank You
- Before You Begin
- Basic plumbing skills are required for installation. If you are unsure of your abilities to install the system using these instructions please hire a qualified plumber.
- Read through your parts list and verify all components are accounted for and in good condition BEFORE scheduling a plumber.
- Please read through the entire instruction manual carefully. If hiring a plumber ensure they have a copy before they start.
- Most common questions are answered in the instructions or FAQ section. If you have read both of those and still have questions you may contact us for further help.
- Plumbing related questions need to be directed to a locally qualified plumber. We are not plumbers and any plumbing questions we receive will not be answered.
- System Requirements
- Before you start plumbing
- Plumbing the system in
- Frequently Asked Questions
____________________________________
Bypass Valve
Depending on your order your system will have either a single piece stainless
steel bypass or a two part plastic bypass with yoke connection. This is what
connects to your control head and provides standard fitting connections to hook
up to your plumbing.
___________________________________________________________________
Drain Fitting
Fitting(s) that connect the control
head to the drain line. Please Note:
Drain line is not included. Depending
on the system ordered there are
multiple options, and the pictures
shown are common examples but
actual fitting may vary.
Before you start plumbing
1. PRE-INSTALLATION PREPARATION
Money-saving tip: If hiring a plumber to do the installation you can save some
money by preparing the tank ahead of time. This cuts down on the time the
plumber has to spend and doing so is simple enough that most people can
accomplish it in less than an hour.