User Guide

- 13 -
DIMPLES
FACING UP
3/4"
DIMPLES
FACING UP
DIMPLES
FACING DOWN
DIMPLES
FACING DOWN
Securing the mounting brackets
The Griplates™ have M4, M5 M6 and M8 hole
patterns to fit the hardware that your flat panel requires.
EXAMPLE
: If your plasma uses M8 x 20 Phillip
screws. Use the M8 mounting points. See figure 7
Bottom of flat
panel
Phillips screw driver
DIMPLES
M8
M6
M5
M4
Once the mounting brackets are aligned secure the
Griplate™ to the flat panel.
Leave a ¾” gap on both mounting brackets as
shown on this diagram.
Do not over tighten the mounting hardware.
The dimples of the top plates have to be
facing up and the bottom dimples must be
facing down. Use (1) Griplate™ per
mounting point. See figure 8.