User Guide

- 10 -
C
L
L
C
Finding center of the flat panel display
Once the flat panel is inverted, use a measuring tape to
find the center of your flat panel measuring from
outside to outside of the chassis. See figure 1.
Using a pencil lightly mark the center of
your flat panel.
See figure 2.
Inverted flat
p
anel
Top of flat panel
Bottom of flat
panel
Mark the center of
the flat panel
Measuring
tape
Inverted flat panel
INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SURFACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A
BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON
THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2)
QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO
COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so
could result in serious personal injury and possible damage to the flat panel.