Specifications

SPI
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 5
You may secure the SpiroLock™ mount to either a single ceiling stud or a solid surface ceiling, such as concrete.
Read these installation instructions thoroughly before attempting to install the Premier Mounts product.
Familiarize yourself with the contents of the package and make sure you have all the parts and tools you need to
safely complete the installation.
Some steps of this installation may require two people to prevent personal injury and/or damage to the projector.
Observe all warnings and utilize proper safety equipment at all times.
Begin installing the SpiroLock™ mount by separating the ceiling plate from the projector plate.
Installing the SpiroLock™ Mount
Use the M5 security Allen wrench to loosen the
M4 x 12mm Lock-It™ screw.

Place one hand under the projector to support it.
®
Lift the locking tab.
¯
While lifting the locking tab, rotate the SpiroLock™
collar assembly 15 degrees clockwise until you hear
an audible “click”.
You may nd it easier to lift the locking tab with
the thumb of the same hand which rotates the
SpiroLock™ collar assembly.
¯
Use both hands to rotate the projector plate as shown
to separate it from the SpiroLock™ collar assembly.
What type of ceiling are you installing to?
If you are installing your SpiroLock™ mount to a
wood stud, proceed to “Wood Stud Installation”
on page 6.
If you are installing your SpiroLock™ mount to a
solid surface, such as a concrete ceiling, proceed
to “Solid Ceiling Installation” on page 7.
Introduction
Step 1
Step 2