Specifications

SPI
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 13
Attaching the Projector to the Mount (cont’d)
Step 3
M6 x 25mm
Lock-It™ Screw
M10 x 10mm
Set Screw
Tighten the M4 x 12mm Lock-It™ screw in the
SpiroLock™ collar assembly.
Alignment & Fine-Tuning

Adjust the pitch, roll, and yaw of the projector up to 6° by rmly grasping the projector with both hands and slowly
tilting it forward, backward, and side-to-side.
®
Make precise adjustments by placing the tip of a at-bladed screwdriver between the projector plate and the lip of
the spindle, then using gentle leverage to make any adjustments.
¯
Tighten the two (2) M10 x 10mm set screws in the spindle and the M6 x 25mm Lock-It™ screw in the bell housing
of the SpiroLock™ mount to lock in your adjustments.
Do not overtighten the two (2) M10 x 10mm set screws.
Do not overtighten the M6 x 25mm Lock-It™ screw.
Projector not shown for clarity.