Specifications

SPI
Page 12 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
Single Mounting Point Installation
Use a single ¼-20 x
5
/16″ screw to attach the SpiroLock™
Projector Plate to the projector if your projector has only
one mounting point.
Do not overtighten the ¼-20 x
5
/16″ screw.
Attaching the Projector Plate (cont’d)
Attaching the Projector to the Mount
If your projector is heavy and/or bulky, two people
may be required to safely attach the projector to the
SpiroLock™ Ceiling Plate.
If your projector is to be mounted higher than
shoulder height, you may need to use one or
more ladders to safely attach the projector to the
SpiroLock™ Ceiling Plate.
Verify that the locking tab on the SpiroLock™ collar
assembly is in the raised position. If the locking
tab is in the lowered position, lift the locking tab
and rotate the SpiroLock™ collar assembly until it
retains the locking tab in the raised position.
Step 1
Step 2
Projector not shown for clarity.
Locking Tab
Raised Position

Raise the projector with the SpiroLock™ Projector
Plate securely attached to the SpiroLock™ Ceiling
Plate.
®
Insert the spindle into the SpiroLock™ collar
assembly.
¯
Press upward and rotate the projector as shown until
the SpiroLock™ collar assembly locks into place. The
SpiroLock™ collar assembly will rotate and produce
an audible “click”.
Did the SpiroLock™ collar assembly lock into place?
If Yes, proceed to Step 3 .
If No, verify that the locking tab on the SpiroLock™
collar assembly is in the lowered position and that
there was an audible “click”. If the locking tab is
in the raised position or you did not hear a “click”,
lower the projector and return to Step 1 .
Locking Tab
Lowered Position