PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 1321 S. State College Blvd.
PFDM2 Maximum Flat Panel Weight: 100 lb. / 45.35 kg.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Introduction Directional Mounting Arrow The Directional Mounting Arrow stamped into the top of the PFDM2 wall mount indicates which edge is the top. Mounting Safety Two people are recommended for the installation of this mount.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 2 Two people are recommended for this step; one person to level the wall plate and another person to mark the wall stud location. Place the wall plate against the wall in the desired nn viewing location. Adjust the wall plate to align the mount slots in the oo wall plate with the center of the wall studs. Level the wall plate.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 4 Place the wall plate against the wall and align it with nn the pilot hole. Insert one (1) 5/16” x 3″ lag bolt and one (1) 5/16” oo washer into the upper right mounting hole and tighten using a socket wrench and 1/2” socket. Do not overtighten the lag bolt. 5 Level the wall plate.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 6 Two people are recommended for this step; one person to level the wall plate and another person to drill the pilot holes. Drill a “pilot hole” in the center of each of the marks with a power drill and a 1/4” drill bit. Only use 1/4” drill bit when drilling the pilot holes. 7 Insert one (1) 5/16” x 3” lag bolt and one (1) 5/16” nn washer into each pilot hole.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Steel Stud Installation 1 The supplied M6 steel stud anchors must be used to install your mount to steel studs. Do not use lag bolts or wood screws. Steel Stud Anchor Screw X Steel Stud Anchor Sleeve Identify the general location on the wall where you nn will be mounting your flat panel.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 3 Use a power drill and 7/16” drill bit to drill a hole at nn each of the marks. Insert a steel stud anchor into each hole. oo If necessary, lightly tap each steel stud anchor into place with a hammer. 4 Use a Phillips screwdriver to tighten each steel stud anchor screw until the legs have completely compressed against the back of the steel stud.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 5 Align the wall plate over the steel stud anchor nn sleeves. Insert a steel stud anchor screw and a washer into oo each steel stud anchor sleeve. Use a Phillips screwdriver and tighten each steel pp stud anchor screw until it is just snug. Do not overtighten the steel stud anchor screws. Do not use a power drill to tighten the steel stud anchor screws.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 2 3 Drill 4 pilot holes of each mark using a power drill nn and 3/8˝ drill bit. Drill 3 inches deep. Insert a concrete wedge anchor into each hole. nn If necessary, lightly tap each concrete wedge anchor into place with a hammer. X4 Finned Anchor Page 10 www.mounts.com | North America 800.368.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids 4 Do not overtighten the mounting screws. X4 5/16” Washer X4 5/16” X 3” LAG BOLT Installing the Mounting Bracket Selecting the Mounting Hardware Insert a small straw or toothpick into the threaded nn inserts found on the back of the flat panel. Use a pencil to mark the depth of the threaded oo insert on the small straw or toothpick.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Universal Washer Installation Premier Mounts’ Universal Washers are designed to accommodate the various M4, M5, M6 and M8 hole sizes required by flat panels. Do not place excessive pressure on the back of the flat panel, as this may damage your flat panel. The Universal Washer must be installed between the head of the mounting screw and the mounting bracket as shown.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Lock and Leveling Screw Installation Leveling Screw Installation You must install the leveling screws before you attach the mounting bracket to the back of the flat panel. The leveling screws consists of two (2) M6 x 75mm screws. Thread one (1) leveling screw into the top mounting hole on each of the mounting brackets.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Ultilizing the Security Barrel Optional security configurations include: Mounting Tab - PCB-CSL1 (sold separately) - Padlock (Combination or Keyed; commercially available) Please read the following directions to install the security barrel: Remove the locking screw from the mounting nn bracket.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Attaching the Flat Panel to the Wall Plate This section requires two people. Do not release your flat panel until you are certain that top and bottom hooks of both mounting brackets are securely seated on the upper and lower mounting rails of the wall panel. Raise the flat panel past the top and bottom nn mounting rails on the wall panel.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Ultilizing the Security Barrel Your PFDM2 Mount includes one (1) Security Barrel which can provide additional theft deterrence for your flat panel. PCB-CSL1 Security Cable the cable through the hole on the security nn Thread barrel. the PCB-CSL1 locking mechanism and oo Attach secure it using the supplied key.
PFDM2 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Lifetime Warranty Premier Mounts warrants all mounting products to be free from defects in material and workmanship for the lifetime of the original installation of the product.
