Specifications

INW-AM325
Installation Instructions Page 7
Final Installation
See the AM3/AM3-B and AM250 Installation Manuals for further instructions.
Place four (4) 1/16” clear bumpers on the mount where the mount comes into contact with either the wall surface or the
INW-AM325.
1. Use eight (8) 5/16” X 1/2” hex head bolts and eight (8) lock
washers to attach the AM3 / AM3-B to the INW-AM325.
2. Tighten using a socket wrench.
1. Use four (4) 5/16” X 1/2” hex head bolts and four (4) lock
washers to attach the AM250 to the INW-AM325.
2. Tighten using a socket wrench
.
AM3/AM3-B
AM3/AM3-B and AM250 Installation
See the AM3/AM3-B and AM250 Installation Instructions for further instructions.
AM250
Special Applications
The following instructions cover special applications. If the stud spacing is more than 16” (i.e. 18”, or stud location), the wall must
be re-inforced. The illustration below will cover how this is done. All previous WARNING: statements apply.
It is best to have a qualified professional install this product.
1. Measure from the wood stud to the edge of the
in-wall box.
2. To make up the distance from the edge of the
in-wall box to the wood stud, spacer boards
must be used.
3. Attach the first spacer board using
commercially available 3” wood screws.
4. Re-measure the distance from the spacer board
to the edge of the in-wall box. If the distance is
greater than 2.5”, attach another spacer board.
5. Please use the supplied wood shims to finish
the installation of the in-wall box (please refer
to Attaching the INW-AM325, page 5).
It is strongly recommended that the
AM3 pivot point (the side the arm is
attached to) be mounted on the
side that DOES NOT have the spacer
boards. The AM3 should be
mounted as tightly as possible against
the wooden wall stud.